1. 中国科学院 山地灾害与地表过程重点实验室,四川,成都,610041
2. 中国科学院 水利部 成都山地灾害与环境研究所,四川,成都,610041
3. 中国科学院大学,北京,100049
纸质出版:2021
移动端阅览
方鑫, 陈晓清, 陈剑刚, 等. 泥石流防治工程混凝土材料的抗冲磨性能[J]. 水土保持通报, 2021,41(4):113-120.
Fang Xin, Chen Xiaoqing, Chen Jiangang, et al. Properties of Abrasion Resistance of Concrete for Debris Flow Mitigation Engineering[J]. Bulletin of Soiland Water Conservation, 2021, 41(4): 113-120.
方鑫, 陈晓清, 陈剑刚, 等. 泥石流防治工程混凝土材料的抗冲磨性能[J]. 水土保持通报, 2021,41(4):113-120. DOI: 10.13961/j.cnki.stbctb.2021.04.016.
Fang Xin, Chen Xiaoqing, Chen Jiangang, et al. Properties of Abrasion Resistance of Concrete for Debris Flow Mitigation Engineering[J]. Bulletin of Soiland Water Conservation, 2021, 41(4): 113-120. DOI: 10.13961/j.cnki.stbctb.2021.04.016.
[目的
]
开展在混凝土中复掺纳米二氧化硅、微硅粉、聚丙烯纤维等材料,增强工程耐磨性的试验研究,探讨复掺材料掺量变化影响抗冲磨强度的规律,旨在为泥石流防护工程建设中抗冲磨混凝土的配合比设计提供科学参考。[方法
]
采用正交试验设计的水下钢球法对混凝土试件进行水下冲磨试验,得出了复掺纳米二氧化硅、微硅粉、聚丙烯纤维的混凝土试件的抗冲磨强度。[结果
]
在选定的掺量范围内,混凝土试件的抗冲磨强度随纳米二氧化硅的增加先增大再减小,在掺量为1.5%时达到最大值;随微硅粉的增加而增大,在掺量为12%时达到最大值;随聚丙烯纤维的增加先减小再增大,在掺量为1.8 kg/m
3
时达到最大值;随着引气剂的增加先减小再增大,在掺量为0.005%时达到最大值。[结论
]
影响混凝土抗冲磨性能最为显著的因素是纳米二氧化硅掺量,其次是聚丙烯纤维,再次是微硅粉,最后是引气剂。
[Objective] Experiments on strengthening the abrasion resistance of mitigation engineering by mixing nano silica
micro silica powder
polypropylene fiber and other materials with concrete were carried out to discuss the laws of the influence of the mixing material content on the abrasion resistance
in order to provide scientific reference for the mix design of abrasion resistance of concrete in the debris flow mitigation engineering. [Methods] The underwater abrasive test of concrete specimens was carried out by using the underwater steel ball method (SL352-2006) designed by orthogonal experimental design method
and the abrasive resistance strength of concrete mixed with nano silica
micro silica and polypropylene fiber was obtained. [Results] Within the range of selected content
the abrasion resistance strength of concrete specimens increased first and then decreased with the raise of Nano-SiO2
and reached the maximum value when the content was 1.5%. With the increase of microsilica powder
the maximum value was reached when the content was 12%. With the increase of polypropylene fiber
it decreased at first
and then increased
and the maximum value was reached when the content was 1.8 kg/m3. With the increase of air entraining agent
it first decreased and then increased
and reached the maximum value when the dosage was 0.005%. [Conclusion] The most significant factor affecting the abrasion resistance strength of concrete is the content of nano silica
followed by polypropylene fiber
micro silica and air entraining agent.
王之君, 李仁年, 拓万全.基于历史观测数据的泥石流突变起动模式研究:以陇南山区白龙江流域为例[J].灾害学, 2019, 34(2):140-144.
安笑, 潘华利, 欧国强, 等. 恒定渗流作用泥石流碎屑物质起动判别模型研究[J].岩土力学, 2020, 41(S1):115-122.
雷鸣宇, 崔一飞, 倪钧钧, 等. 浅层滑坡型火后泥石流起动机理研究进展与案例分析[J].工程地质学报, 2021, 29(3):786-797.
李睿祺, 胡桂胜, 杨志全, 等. 都汶高速公路银杏坪沟大规模泥石流运动特征与堵溃分析[J].成都理工大学学报(自然科学版), 2020, 47(5):625-634.
栗帅, 陈晓清, 陈剑刚, 等. "阶梯+消力墩"型排导槽调控泥石流性能研究[J].工程科学与技术, 2021, 53(3):68-76.
毕远宏, 丛凯.基于小流域暴雨洪峰理论的泥石流汇流模拟:以马家沟泥石流为例[J].甘肃地质, 2020, 29(Z1):73-78.
陈亮, 刘珍, 肖捷.云南省新平县那板箐泥石流发育特征及风险评价[J].地质灾害与环境保护, 2020, 31(1):17-22.
徐根祺, 温宗周, 李丽敏, 等. 监测预警技术在泥石流灾害中的应用研究[J/OL].有色金属科学与工程:1-9. (2021-05-05)[2021-04-30].
Chen Jiangang, Chen Xiaoqing, Wang Tao, et al. Types and causes of debris flow damage to drainage channels in the Wenchuan Earthquake area[J]. Journal of Mountain Science, 2014, 11(6):1406-1419.
周富春, 黄本生, 杨钢, 等. 稀性泥石流对排导槽的冲磨破坏机理[J].山地学报, 2001, 19(5):470-473.
李光宇, 张海燕, 曹四伟.水工混凝土抗冲磨材料的应用进展[J].路基工程, 2009(2):165-166.
唐明, 巴恒静, 李颖.纳米级SiO
x
与硅灰对水泥基材料的复合改性效应研究[J].硅酸盐学报, 2003(5):523-527.
Nazari Ali, Riahi Shadi. Compressive strength and abrasion resistance of concrete containing SiO
2
and Cr
2
O
3
nanoparticles in different curing media[J]. Magazine of Concrete Research, 2012, 64(2):177-188.
陈安生, 唐小萍.纳米SiO
2
对不同强度等级混凝土性能的影响[J].硅酸盐通报, 2013, 32(8):1521-1527.
Cheng An, Lin Weiting. Abrasion resistance of concrete containing polyolefin fibers and silica fumes[J]. Polymers and Polymer Composites, 2014, 22(5):437-442.
Zoran J G, Gordana A T C, Nenad S R, et al. Abrasion resistance of concrete micro-reinforced with polypropylene fibers[J]. Construction and Building Materials, 2012, 27(1):305-312.
胡金生, 杨秀敏, 周早生, 等. 钢纤维混凝土与聚丙烯纤维混凝土材料冲击荷载下纤维增韧特性试验研究[J].建筑结构学报, 2005, 26(2):101-105.
张文平.新型混凝土引气剂和防冻剂研究[D].辽宁大连:大连理工大学, 2006.
Xiao Huigang, Liu Rui, Zhang Fengling, et al. Role of nano-SiO
2
in improving the microstructure and impermeability of concrete with different aggregate gradations[J]. Construction and Building Materials, 2018, 188:537-545.
Wang L, Zhou S H, Shi Y, et al. Effect of silica fume and PVA fiber on the abrasion resistance and volume stability of concrete[J]. Composites Part (B), 2017, 130:28-37.
徐迅, 卢忠远.纳米二氧化硅对硅酸盐水泥水化硬化的影响[J].硅酸盐学报, 2007, 35(4):478-484.
崔鹏, 唐金波, 林鹏智.泥石流运动阻力特性及其研究进展[J].四川大学学报(工程科学版), 2016, 48(3):1-11.
陈永根.龄期对不同掺料相变混凝土力学性能影响试验与分析[J].湖南文理学院学报(自然科学版), 2019, 31(4):53-57, 63.
邓明枫, 钟强, 张立勇, 等. 高性能混凝土抗冲磨性能试验研究[J].混凝土, 2008(2):82-83, 86.
赵正, 刘健, 徐晶, 等. 超高性能纤维增强水泥基复合材料的抗冲磨性能研究[J].河北工业大学学报, 2015, 44(6):108-111.
孙玲玲.基于QFD和DOE的产品优化设计研究[D].浙江杭州:浙江大学, 2011.
唐佳丽, 徐章韬.正交试验中的极差分析与方差分析[J].中学数学, 2017(9):31-34.
张密林, 丁立国, 景晓燕, 等. 纳米二氧化硅的制备、改性与应用[J].化学工程师, 2003(6):11-14.
Jo Byungwan, Kim Changhyun, Lim Jaehoon. Investigations on the development of powder concrete with nano-SiO
2
particles[J]. KSCE Journal of Civil Engineering, 2007, 11(1):37-42.
梁宁慧.多尺度聚丙烯纤维混凝土力学性能试验和拉压损伤本构模型研究[D].重庆:重庆大学, 2014.
0
浏览量
881
下载量
0
CSCD
关联资源
相关文章
相关作者
相关机构
京公网安备11010802024621